How to properly inject Trenbolone Enanthate or other steroids


Injections of Trenbolone Enanthate require compliance with certain rules and recommendations that will increase the effectiveness of the cycle and overall health of the individual. Those who disregard the recommended or suggested dosages will increase their chances of negative side effects. Dosages and the frequency of injections will vary for each athlete or bodybuilder. Other key factors to consider when properly injecting Trenbolone Enanthate or any other steroid is the length of cycle and the goal of the individual. You will hear opinions and get advice from steroid users of all levels.  So, how do you know what advice to take?  Take the advice we give on our site.  Please, remember that if you are uncomfortable with self-injecting and have never done this before, it’s okay to ask someone for help.  Better safe than sorry, right?

Our recommended company for buying Trenbolone Enanthate

How to inject Trenbolone Enanthate?

Before the injection it is important to prepare the drug itself. The presence of steroids with a concentration of 250 mg / ml would be the best option. Thus, the athlete will be more able to accurately calculate the required dose in compliance with all recommendations of the cycle. Preparation for injections is carried out in the following steps:

  • Open the glass ampule or vial;
  • Fill the syringe with the desired dosage;
  • Treat the injection site with an alcohol absorbed cotton swab;
  • Make sure you have no air bubble in the syringe;
  • Inject the steroid intramuscularly;
  • Reapply alcohol to site after injecting the steroid.

Before injecting the steroid, it is suggested to rub the bottle in between both hands to warm up the steroid. Once heated, the steroid is ready to inject. It is important to note that injections are performed exclusively intramuscularly. The best areas to inject are the upper part of the thigh, shoulder or glutes. It is crucial to never inject in the same area twice. Always rotate your injections to allow time for the site to heal. When injecting in any of the areas mentioned above, do so without flexing your muscles because this makes it harder for the needle to go through the muscle.

To get more comfortable with self-injections, some suggest standing in front of a mirror. This will allow you to see the exact spot you are going to inject. It will also make you more comfortable with the motion of slowly pushing the solution into the muscle. Practice makes perfect. Everyone has to start somewhere, right?

Can I give injections myself?

Most experienced athletes and professional bodybuilders will inject themselves. However, there are times when even the most experienced cannot inject themselves and will ask someone to assist. Preparing the injection is not complicated; however, many will struggle with the injection itself until they become more experienced with the procedure. Being nervous or hesitant is not uncommon but the best thing to do is not think about it too much. Know the area where you are going to inject and simply do it. Once you stick the needle in, do not hesitate to release the steroid into the area. Push the pin in a continuous and steady motion until the syringe is completely empty. At that point, massage the area by rubbing it in a circular motion for a few minutes. This will allow the steroid to go through the muscle and be absorbed easier.

3 Comments

  • Liam Cotter

    March 28, 2020 @ 3:18 am

    Hi iam on my first cycle and buying black market gear. I am in australia and need a recommended supplier who will deliver and not just take your money . Please refer me to a genuine site who can actaully garunter delivery. Iam looking at spending $1000 on tren test dbal and hgh
    Also im a skinny dude n want to bulk.what do i buy propinate,cyponate or ethanate
    Thankyou for any advice you can give

  • Lee Kilgore

    May 4, 2020 @ 11:21 am

    Would like to purchaser

Leave a Reply

Your email address will not be published. Required fields are marked *